1. Drill a small hole in the end of the RH fairing pocket, slip the wires through and connect them up to your fuse block:

2. Place velcro on both the back of the fuse block and the inside of the fairing pocket and put in place:

3. Now cut out a piece of plexiglass so that it will lay on top of the plastic that sticks out from the side of the pocket (see picture above just to the lower left of the fuse block and to the right). Note: the hole in the plexiglass is there so that you can use a key to lift it out:

4. Lay the plexiglass inside noting that it rests on the supports that jut out from the side of the fairing pocket. The fuse block is now protected creating an upper compartment that can be used for storage:

5. This is where I usually put my cell phone so I place a piece of soft foam rubber in the upper compartment and put my cell phone on top:

@ Back to Motorcycle Main Page

@ Home